The Ideal Pet Original Plastic Pet Door is designed for installation in sliding glass doors. Installation requires removing the existing lock catch plate and utilizing mounting hangers and seal extrusions. The documentation emphasizes careful reading of instructions and ensuring all necessary parts are present before beginning the installation process. The pet door can be installed on either the right or left side, depending on the sliding door’s opening direction. Additional components, such as the “H” Section Filler, may be required depending on the height of the sliding glass door.
Preparing for Installation
Before commencing installation, it is important to verify that all components are accounted for. The documentation states the need to review all instructions carefully. The pet door is compatible with sliding glass doors and can be adapted for either right or left-hand operation, contingent upon the sliding door’s opening mechanism. A crucial initial step involves removing the existing lock catch plate from the sliding door frame, as its presence will impede the proper installation of the pet door. This is detailed in Picture #1 of the installation materials.
Mounting the Pet Door
The 150 Series V.I.P. Pet Door comes equipped with two mounting hangers – one for the top and one for the bottom – already attached. These hangers are integral to securing the pet door to the sliding door frame. The installation process begins with mounting the pet door to the sliding door frame using these pre-attached hangers.
Installing the Lock Catch
The installation process includes installing a lock catch. Users are instructed to place the lock catch onto the existing door lock hook in the up, or locked, position. To accurately position the lock catch, partially close the sliding door and mark the location of the top edge of the lock catch inside the pet door frame. This marking ensures proper alignment and functionality of the locking mechanism. Picture #19 illustrates this step.
Adding the “H” Section Filler
An “H” Section Filler is included to bridge any gaps that may exist. This component is slid onto the top of the door, over the springs. A specific note indicates that if the sliding glass door measures 83 inches (6 feet 11 inches) in height, an additional “H” Top Section may be necessary. This additional part can be obtained by contacting the manufacturer at (800) 378-4385 and will be shipped for a small fee.
Completing the Installation: Seals and Draft Stoppers
The final stages of installation involve adding the door seal and draft-stopper. The pet door includes two seal extrusions that are mounted into the slots located on the side of the V.I.P. Pet Door panel. Proper measurement is critical for effective sealing. To determine the correct length for installation, the sliding door should be closed against the pet door, and the distance from the top of the slider to the bottom sill of the door frame should be measured. This measurement ensures a snug fit and minimizes drafts.
Installation Resources
Ideal Pet Products provides installation videos and instructions to assist users. These resources are available online and are intended to simplify the installation process. The documentation states that installing the doors is designed to be easy enough for a human to accomplish. The installation page contains all necessary information for installing the Ideal Pet door. The documentation also references “Helpful tips on making the most of this crazy life with pets,” suggesting a broader range of resources may be available on the manufacturer’s website.
Important Considerations
The documentation highlights the importance of careful preparation and adherence to the provided instructions. Removing the existing lock catch plate is identified as a critical preliminary step. The potential need for an additional “H” Section Filler, depending on the height of the sliding glass door, is also noted. Accurate measurement for the seal extrusions is emphasized to ensure a proper seal and minimize drafts.
The provided source material is insufficient to produce a 2000-word article. Below is a factual summary based on available data.
Conclusion
The Ideal Pet Original Plastic Pet Door installation process involves several key steps, beginning with preparation and component verification. Removing the existing lock catch plate, mounting the door with the provided hangers, installing the lock catch, adding the “H” Section Filler (if necessary), and completing the installation with seals and draft stoppers are all essential components of a successful installation. The manufacturer provides installation videos and instructions to aid users. Careful attention to detail and accurate measurements are crucial for ensuring a secure and effective pet door installation.