The Ideal Pet Original Plastic Pet Door is designed for installation in existing sliding glass doors. Installation involves removing components from the existing door frame, mounting the pet door panel, and securing it with provided hardware. The documentation emphasizes careful reading of instructions and ensuring all necessary parts are present before beginning the installation process. The door can be installed on either the right or left side, depending on the sliding door’s operation.
Preparing for Installation
Before commencing installation, it is important to verify that all required components are available. The documentation states the need to review all instructions carefully prior to starting. A key initial step involves removing the existing Lock Catch plate from the sliding door frame, as this plate will interfere with the installation of the new pet door. The pet door includes Mounting Hangers, both top and bottom, which are pre-attached. The documentation notes that the pet door may be installed on either the right or left side, contingent upon the direction in which the sliding door opens.
Step-by-Step Installation Procedure
The installation process involves several distinct steps. First, the Mounting Hangers are utilized to secure the pet door to the sliding door frame. Following this, an “H” Section Filler is slid onto the top of the door, positioned over the springs. A specific note indicates that if the sliding glass door measures 83 inches (6 feet 11 inches) in height, an additional “H” Top Section may be required. This additional section can be obtained by contacting the manufacturer at (800) 378-4385 and will be shipped for a small fee.
Next, the Lock Catch is installed onto the existing door lock hook in the up, or locked, position. With the sliding door partially closed, the location of the top edge of the Lock Catch is marked inside the pet door frame. This marking ensures proper alignment and functionality of the locking mechanism.
Completing the Installation: Seals and Draft Stoppers
The final stage of installation involves adding the door seal and Draft-Stopper™. Two Seal Extrusions are included with the pet door and are mounted into the slots located on the side of the V.I.P. Pet Door panel. Proper measurement is crucial during this step. To accurately measure for installation, the sliding door is closed against the pet door, and the length from the top of the slider to the bottom sill of the door frame is measured. This measurement ensures a snug fit and effective sealing against drafts.
Component Details
The Ideal Pet Original Plastic Pet Door includes several key components:
- Mounting Hangers (top and bottom)
- “H” Section Filler
- Lock Catch
- Seal Extrusions
- Draft-Stopper™
The documentation highlights the importance of the “H” Section Filler, particularly for doors exceeding a specific height (83 inches). The inclusion of Seal Extrusions and a Draft-Stopper™ indicates a focus on minimizing drafts and maintaining energy efficiency.
Installation Resources
Ideal Pet Products provides installation videos and instructions to assist users. These resources are available on the company’s website and are intended to simplify the installation process. The documentation states that installation is designed to be straightforward, even for individuals without extensive DIY experience. The website offers specific installation guidance for different door models.
Considerations for Sliding Door Height
A specific consideration is noted regarding the height of the sliding glass door. Doors measuring 83 inches (6 feet 11 inches) tall may require an additional “H” Top Section. The documentation explicitly advises contacting the manufacturer at (800) 378-4385 to obtain this additional part, which will be shipped for a nominal shipping charge. This highlights a potential need for supplemental components based on the dimensions of the installation location.
Lock Catch Installation Details
The Lock Catch plays a crucial role in securing the pet door. The documentation details the process of placing the Lock Catch onto the existing door lock hook in the up (locked) position. Marking the location of the top edge of the Lock Catch inside the pet door frame is essential for proper alignment. This ensures that the sliding door can be securely locked when the pet door is in place.
Sources
- Ideal Pet Original Plastic Pet Door Installation
- Installation Videos
- Ideal Pet Products 150-Series Manual
The provided source material is insufficient to produce a 2000-word article. Below is a factual summary based on available data.